Initial Start Up; Initial Start Up For A System Without Connection To An Expansion Controller (Pac-Yg50Eca) - Mitsubishi Electric AG-150A Instruction Book

5. Initial Start up

5-1 Initial start up for a system without connection to an expansion controller
(PAC-YG50ECA)
Touch [Unit Info]
Touch [Network]
Touch [Groups]
After the power is turned on, the language selection window will appear.
Select the language to be used for display, and then touch [OK].
Note: It will take approximately 20 seconds for the display to appear after
the power is turned on.
When the language is selected, the Date and Time setting window will
appear. Set the date and time. (Refer to Section 7-3 for the details on how
to set the date and time.)
* The initial setup sequence does not set the date and time correctly. Be
sure to manually set the correct date and time.
* Touch the [Save Settings] button to reflect the changes.
After setting the date and time, touch the [Unit Info.] tab and set the Name
and Unit ID. Be sure to set the Expansion Controller setting to "Do not use."
(Refer to Section 7-5 for the details on how to set the Name and Unit ID.)
After making the unit settings, touch the right arrow to show the [Network]
tab and touch it. Set the IP address and M-NET address. (Refer to Section
7-6 for the details on how to set the IP address and M-NET address.)
– 13 –