Mitsubishi Electric AG-150A Instruction Book page 17

After the network settings have been made, touch [Groups], select the EC
number from the tab menu, and make the group settings for each EC.
* The settings for the units that are connected to a different expansion
controller cannot be made.
(Refer to Section 7-7 for the details of how to make the settings.)
Make other settings such as block settings and interlocked LOSSNAY
settings. Refer to appropriate sections in Chapter 7 on how to make the
settings.
Configure the floor layout on the [Floor Layout] window if necessary.
* When the unit is started up again, the [Operation/Monitor], instead of the
Initial Settings window, will appear. To change certain settings, refer to
Section 7-1 Calling up the initial setting window to change the settings.
The Date and Time setting window will appear. Set the date and time.
(Refer to Section 7-3 for the details on how to set the date and time.)
* The initial setup sequence does not set the date and time correctly. Be
sure to manually set the correct date and time.
* Touch the [Save Settings] button to reflect the changes.
When the above settings have been made, the initial settings are complete.
Touch the on the top right hand of the screen to go into the [Operation/
Monitor] window.
– 16 –