Mitsubishi Electric AG-150A Instruction Book page 15

After making the network settings, touch the [Groups] tab, and make the
settings. (Refer to Section 7-7 for the details on how to make the group
settings.)
Make other settings such as block settings and interlocked LOSSNAY
settings. Refer to appropriate sections in Chapter 7 on how to make the
settings.
When the above settings have been made, the initial settings are
completed.
Touch the on the top right hand of the screen to go into the [Operation/
Monitor] window.
Configure the floor layout on the [Floor Layout] window if necessary.
* When the unit is started up again, the [Operation/Monitor], instead of the
Initial Settings window, will appear. To change certain settings, refer to
Section 7-1 Calling up the initial setting window to change the settings.
After moving to the [Operation/Monitor] window, the startup screen will
appear.
Startup takes a maximum of five minutes after the message appears. (It
takes about two to three minutes when no communication errors occur.)
– 14 –