7 PROGRAMMING FOR EXECUTING THE MASTER FUNCTION
7.3.1 Program example using the utility package
7 - 10
(1) When using auto configuration
POINT
(1) Pre-determine the slave node settings (e.g. connection type) before executing
auto configuration.
(2) Check that the power of the slave nodes and the network is ON and the wiring
is correct.
(a)
The setting items for auto configuration are shown below.
1)
Scroll the [Monitor/Test] screen, and bring up the auto configuration
setting area.
For information on how to display the [Monitor/Test] screen, refer to
Section 6.3.
2)
Perform auto configuration according to the following steps 1 to 5.
1. Stop I/O communication. (Refer to (b).)
2. Set auto configuration operation. (Refer to (c).)
3. Execute auto configuration (Refer to (d).)
4. Confirm auto-configured parameters. (Refer to (e).)
5. Save parameters to flash ROM. (Refer to (3).)
MELSEC-Q
2)
1)
7 - 10