Table of Contents
Advertisement
6 UTILITY PACKAGE (GX Configurator-DN)
6 - 7
(2) Data created with the utility package
The following data or files that are created with the utility package can be also
handled in GX Developer. Figure 6.1 shows respective data or files are handled
in which operation.
<Intelligent function module parameter>
(a)
This represents the data created in Auto refresh setting, and they are
stored in an intelligent function module parameter file in a project created
by GX Developer.
Project
Program
Parameter
(b)
Steps 1) to 3) shown in Figure 6.1 are performed as follows:
1)
From GX Developer, select:
[Project]
2)
From the module selection screen of the utility, select:
[Intelligent function module parameter]
parameters]
3)
From GX Developer, select:
[Online]
module parameters"
Or, from the module selection screen of the utility,
[Online]
PLC Parameter
Network Parameter
Intelligent Function Module Parameter
[Open project] / [Save]/ [Save as]
[Read from PLC] / [Write to PLC] "Intelligent function
[Read from PLC] / [Write to PLC]
MELSEC-Q
[Open parameters] / [Save
6 - 7
Advertisement
Table of Contents
Troubleshooting
