8 PROGRAMMING FOR EXECUTING THE SLAVE FUNCTION
8 - 6
8)
If parameter check has failed, "Error Occurred" is displayed for "X08:
Error Set Signal for Slave Function".
Check the error code in the current value column of "Error Information
for Slave Function", and take corrective actions. (Refer to Section
9.2.1.)
9)
After completing the parameter saving to the flash ROM, set "OFF" for
"Y17: Request for Saving Parameters to Flash ROM".
Select "OFF"
10) Click the Close button.
POINT
Since the number of writes to flash ROM is limited, use Request for Saving
Parameters to Flash ROM (Y17) only when creating or changing parameters.
(3)
When clearing parameters from the flash ROM
Refer to Section 7.3.1 (4).
Execute test button
MELSEC-Q
8 - 6