Table of Contents
Advertisement
7 PROGRAMMING FOR EXECUTING THE MASTER FUNCTION
7 - 18
(3)
When saving the parameters to a flash ROM
Clicking the Flash ROM Save button on the [Monitor/Test] screen will display the
[5. Save Parameters to Flash ROM.] or [Save Parameters to Flash ROM] screen.
(The same setting details are displayed on the both screens.)
Follow the setting instructions.
POINT
Save the parameters in the buffer memory to a flash ROM. Otherwise, they are
cleared when the power is turned OFF or the CPU module is reset.
1)
When the current value for "Y11: I/O Communication Request" is "I/O
Comm. Request", set "I/O Comm. Stop Request".
Select "I/O Comm. Stop Request"
2)
When the current value for "X01: I/O Communicating" is "I/O
Communicating", set "I/O Comm. Request" for "Y11: I/O
Communication Request".
Select "I/O Comm. Request"
Then, set "I/O Comm. Stop Request" for "Y11: I/O Communication
Request".
Select "I/O Comm. Stop Request"
Check that the current value for "X01: I/O Communicating" was
changed to "I/O Comm. Stop".
3)
When the current value for "Y15: Auto Configuration Request" is
"Config. Request", set "OFF" for "Y15: Auto Configuration Request".
Select "OFF"
Execute test button
Execute test button
Execute test button
Execute test button
MELSEC-Q
1)
2)
3)
7 - 18
Advertisement
Table of Contents
Troubleshooting
