Mitsubishi Electric QJ71DN91 User Manual page 153

7 PROGRAMMING FOR EXECUTING THE MASTER FUNCTION
7 - 20
8) If parameter check has failed, "Error Occurred" is displayed for "X03:
Error Set Signal for Master Function".
Check the error code in the current value column of "Error Information
for Master Function", and take corrective actions. (Refer to Section
9.2.1.)
9) After completing the parameter saving to the flash ROM, set "OFF" for
"Y17: Request for Saving Parameters to Flash ROM".
Select "OFF"
10) Click the Close button.
POINT
Since the number of writes to flash ROM is limited, use Request for Saving
Parameters to Flash ROM (Y17) only when creating or changing parameters.
Execute test button
MELSEC-Q
7 - 20