Table of Contents
Advertisement
7 PROGRAMMING FOR EXECUTING THE MASTER FUNCTION
7 - 16
(2) When setting parameters manually
(a)
Set the parameters for master function.
Clicking the Parameter Area Monitor/Test button on the [Monitor/Test]
screen will display the [Parameter Area Monitor/Test] screen.
For information on how to display the [Monitor/Test] screen, refer to Section
6.3.
1)
Set parameters for 1st to 4th slave nodes. (For the setting details, refer
to Section 7.3 (1).)
Select a value in a Setting value field
Repeat this if more than one parameter must be set.
2)
To start I/O communication automatically at power-up, set "Start" for
"Auto Communication Start Setting".
Select "Start"
3)
Click the Close button.
Execute test button
MELSEC-Q
Execute test button
7 - 16
1)
2)
3)
Advertisement
Table of Contents
Troubleshooting
