5 SETUP AND PREPARATION
5.1.2 When using the slave function
Perform hardware test. (Mode 9)
Set node No.
Set mode to 3, 4, or 5.
Connect DeviceNet cable to QJ71DN91.
Use GX Configurator-DN?
Parameters for slave function (See Section 8.2.1 (1).)
Set parameters for slave function.
Not needed unless I/O points for slave function are
changed.
Auto communication start setting (See Section 8.2.1 (1).)
5
Set auto communication start setting. Not needed when starting
I/O communication by I/O Communication Request (Y11).
Saving parameters to flash ROM (See Section 8.2.1 (2).)
Save parameters to flash ROM.
Refresh setting (See Section 8.3.1.)
Configure auto refresh settings. Write intelligent
function module parameters to CPU module.
Programming for control (See Section 8.3.1.)
Create sequence program for control. After writing it to
programmable controller, reset CPU module.
5 - 2
Start
Not use
Use
Failed
Test run
OK
Operation
(See Section 5.4.)
(See Section 5.3.2.)
(See Section 5.3.3.)
(See Section 5.5.)
Parameters for slave function (See Section 8.2.2 (1).)
Create sequence program for setting parameters for
slave function. Not needed unless I/O points for slave
function are changed.
Auto communication start setting (See Section 8.2.2 (2).)
Create sequence program for auto communication start
setting. Not needed when starting I/O communication
by I/O Communication Request (Y11).
Saving parameters to flash ROM (See Section 8.2.2 (2).)
Create sequence program for saving parameters to
flash ROM.
Refresh setting (See Section 8.3.2.)
Create sequence program for refresh.
Programming for control (See Section 8.3.2.)
Create sequence program for control. After writing it to
programmable controller, reset CPU module.
Test run
Set Request for Saving Parameters to Flash ROM
(Y17) to ON to save parameters to flash ROM.
MELSEC-Q
Failed
OK
5 - 2