Table of Contents
Advertisement
6 UTILITY PACKAGE (GX Configurator-DN)
6 - 18
[Explanation of items]
(1) Items
Setting item:
Displays I/O signals and buffer memory names.
Current value:
Monitors the I/O signal states and present buffer memory values.
Setting value:
Enter or select values to be written into the buffer memory for test
operation.
(2) Command buttons
Write to module
Read from module
Save file
Load file
Current value display
Make text file
Start monitor /
Stop monitor
Execute test
Close
REMARK
The "Execute test" operation is explained below, using an example of writing data to
"Failed Node Detection Setting".
(1)
Change the setting value for "Node 1" to "Do not detect".
Nothing is written to the QJ71DN91 at this point.
(2)
Click the setting value field of "Node 1" to select.
To write more than one setting item at the same time, select the items while
holding down the Ctrl key.
(3)
Click Execute test to execute the write operation.
Upon completion of writing, the display in the current value field will change to
"Do not detect".
Writes parameters to the flash ROM of the QJ71DN91.
Reads parameters from the flash ROM of the
QJ71DN91.
Saves parameters on the hard disk, etc.
Reads parameters saved on the hard disk, etc.
Displays the current value of the item selected. (This is
used to check the text that cannot be displayed in the
current value field. However, in this utility package, all
items can be displayed in the display fields).
Creates a file containing the screen data in text file
format.
Selects whether or not to monitor current values.
Performs a test on the selected items. To select more
than one item, select them while holding down the
Ctrl key.
Closes the screen that is currently open and returns to
the previous screen.
MELSEC-Q
6 - 18
Advertisement
Table of Contents
Troubleshooting
