Specifications - Ametek IntelliPoint RF RMT Series Installation And Operating Instructions Manual

Two-wire point level switch with manual calibration/set point
Table of Contents

Advertisement

Section 6: Specifications
Technology:
Calibration:
Modes of Operation:
Repeatability:
Response Time:
Time Delay:
Ambient Electronics:
Storage Temperature:
Indicators:
Self-Check:
Power Supply:
Power Consumption:
Output:
Housing (Electronics):
Cable Entry:
Ingress Protection:
RF/Capacitance
None
High and Low level
2mm (0.08 inch) conductive liquids
Less than 1 second
0 to 60 seconds forward and reverse acting
-30 to 70°C (-28 to 158°F) ATEX/IECEx
-40 to 70°C (-40 to 158°F) FM/FMc
-40 to 85°C (-40 to 185°F)
LEDs: Green Power, Red Alarm Status
Manual Certify
13 to 30 VDC
Note: The minimum supply voltage
at the transmitter terminal is:
13 VDC at 22mA (Fault)
19 VDC at 5mA (Fault)
1 watt maximum
8 mA - Alarm
16 mA - Normal
22 mA - Fault
(or field-selectable)
8 mA - Normal
16 mA - Alarm
5 mA - Fault
Dual Compartment, powder-coated
aluminum with two cable entries
M20 x 1.5 ATEX/IECEx
¾-inch NPT FM/FMc
IP66 NEMA 4X
34

Specifications

Advertisement

Table of Contents
loading

This manual is also suitable for:

Intellipoint rf rgt series

Table of Contents