Table of Contents
Advertisement
RMTXX1 Series - IntelliPoint RF™ Instruction Manual
2.8
Sensing Element Connection
Sensing element connects to the rear side of the circuit board
and is factory-installed.
The sensing element is sealed to the housing and cannot be
removed without permanent damage.
For IntelliPoint RF instruments that are mounted remotely
from the sensing element, an additional housing with
terminals is provided to connect the cable from the sensing
element. This housing is factory wired to the Intellipoint
circuit board. Ref Figure 2-7. Connect Green (Ground)
wire to green screw, Red (Shield) wire to red screw, and Blue
(Center) wire to blue screw.
Sensing Element Connection
12
Turn at Wrench Flats
Figure 2-6
(Integral Housing)
Advertisement
Table of Contents
