Table of Contents
Advertisement
Installation
2.8
Sensing Element Connection
Sensing element connects to the rear side of the circuit board
and is factory-installed.
The sensing element is sealed to the housing and cannot be
removed without permanent damage.
For IntelliPoint RF instruments that are mounted remotely
from the sensing element, an additional housing with terminals
is provided to connect the cable from the sensing element. This
housing is factory wired to the Intellipoint circuit board. See
Figure 2-7. Connect Green (Ground) wire to green screw, Red
(Shield) wire to red screw, and Blue (Center) wire to blue screw.
Sensing Element Circuits Side
Figure 2-6
Sensing Element Connection
(Integral Housing)
15
Advertisement
Table of Contents
