Table of Contents
Advertisement
IntelliPoint RF RML Series
2.8
Sensing Element Connection
Sensing element connects to the rear side of the circuit board
and is factory-installed.
The sensing element is sealed to the housing and cannot be
removed without permanent damage.
For IntelliPoint RF instruments that are mounted remotely
from the sensing element, the cable connections from the
sensing element to the electronic unit are made to the
terminals on the sensing element side of the housing. See
Figure 2-8. Connect Green (Ground) wire to green screw,
Red (Shield) wire to red screw, and Blue (Center) wire to blue
screw.
Sensing Element Connection
12
Figure 2-7
(Integral Housing)
Installation
Advertisement
Table of Contents
