Table of Contents
Advertisement
2. Getting Started/Basic Operations
Entering Text
Follow the steps below when the text entry screen is displayed.
1
Press 3/4/2/1 to select text and then
press [MENU/SET] to register.
• To enter the same character again, perform either of the
following operations to move the cursor.
– Rotate the control dial to the right.
– Rotate the zoom lever to the [T] side.
• Operations when the items below are selected
– [
]:
– []]:
– [Delete]:
– [ ]:
– [ ]:
¢1 You can also switch between text modes by pressing [DISP.].
¢2 You can also move the entry position with the zoom lever or control dial.
• A maximum of 30 characters can be entered.
(Maximum of 9 characters when setting names in [Face Recog.])
• A maximum of 15 characters can be entered for [ ], [ ], [ ], [ ] and [ ].
(Maximum of 6 characters when setting names in [Face Recog.])
2
Press 3/4/2/1 to select [Set], and then press [MENU/SET] to end
the entry.
Switch text between [A] (upper case characters), [a] (lower case
characters), [1] (numbers), and [&] (special characters)
Enter a blank
Delete a character
Move the entry position cursor to the left
Move the entry position cursor to the right
¢2
¢2
56
¢1
Advertisement
Table of Contents
