Table of Contents
Advertisement
12. Connecting to other equipment
Saving still pictures and motion pictures on a
Recorder
You can connect the camera to a Panasonic Blu-ray disc or DVD recorder and store
pictures and motion pictures on it.
1
Connect the recorder and camera with the USB connection cable
(supplied).
• Before connecting, turn on the camera and the recorder.
• Check the direction of the terminals and plug in/out straight holding onto the plug.
(It may result in malfunction by the deforming of the terminal if it is plugged in obliquely
or in wrong direction.)
Do not connect devices to incorrect terminals. Doing so may cause malfunction.
• Do not use any other USB connection cables except the supplied one.
• A message about charging may be displayed. Wait until the display disappears.
A [USB/CHARGE] socket
B USB connection cable (supplied)
2
Press 3/4 to select [PC(Storage)], and then press [MENU/SET].
• If you set the [USB Mode] to [PC(Storage)] in the [Setup] menu, the [USB Mode]
selection screen will not be displayed and the camera will automatically connect to the
recorder.
3
Operate the recorder to copy.
• See the operating instructions for the recorder about the details about copying and
playing back.
• Modes such as 4K motion picture may not be supported depending on the recorder
being used.
• Use a sufficiently charged battery or an AC adaptor (optional) and DC coupler (optional). If the
remaining battery power becomes low while the camera and the recorder are communicating,
the alarm beeps. In that case, cancel copying immediately. Otherwise. damage may be
caused to the data.
• Before removing or inserting the card, turn off the camera and disconnect the USB connection
cable. Otherwise, damage may be caused to the recorded data.
279
Advertisement
Table of Contents
