Panasonic LUMIX DC-LX100M2 Operating Instructions Manual page 281

17mp four thirds mos sensor
Hide thumbs Also See for LUMIX DC-LX100M2:
Table of Contents

Advertisement

12. Connecting to other equipment
Selecting multiple pictures and printing them
1
Press 3 to select the multiple printing setting in step
Pictures" (P280).
2
Press 3/4 to select an item and then press [MENU/SET].
[Multi Select]
[Select All]
[Rating]
3
Press 3/4 to select [Print start] and then press [MENU/SET].
• Group pictures will not be displayed as group pictures but as single pictures.
• Disconnect the USB connection cable after printing.
• Use a sufficiently charged battery or an AC adaptor (optional) and DC coupler (optional). If the
remaining battery power becomes low while the camera and the printer are connected, the
alarm beeps. If this happens during printing, stop printing at once. If not printing, disconnect
the USB connection cable.
• Before removing or inserting the card, turn off the camera and disconnect the USB connection
cable. Otherwise, damage may be caused to the recorded data.
• Some printers can print directly from the card removed from the camera. For details, refer to
the operating instructions of your printer.
• The camera is receiving an error message from the printer when the [¥] indication lights
yellow during printing. After finishing printing, make sure there are no problems with the
printer.
• If the number of prints is high, the pictures may be printed several times. In this case, the
remaining number of prints indicated may differ from the number set.
• Only pictures taken in JPEG format can be printed. Those taken in RAW will use the JPEG
pictures that were simultaneously created. If an equivalent JPEG picture is not available, no
print will take place.
Not available in these cases:
• Motion pictures, 4K burst files, and images recorded with the Post Focus function cannot be
printed.
Multiple pictures are printed at one time.
• Press 3/4/2/1 to select the pictures and then press [MENU/
SET].
(Press [MENU/SET] again to cancel the setting.)
• After the pictures have been selected, press [DISP.].
Prints all the stored pictures.
Prints all images with [Rating] levels between [¿1] and [¿5].
281
3
of "Printing the

Advertisement

Table of Contents
loading

Table of Contents