Panasonic LUMIX DC-LX100M2 Operating Instructions Manual page 304

17mp four thirds mos sensor
Hide thumbs Also See for LUMIX DC-LX100M2:
Table of Contents

Advertisement

13. Others
AC adaptor (supplied)
• If you use the AC adaptor (supplied) near a radio, the radio reception may be disturbed.
Keep the AC adaptor (supplied) 1 m (3.3 feet) or further away from radios.
• The AC adaptor (supplied) may generate whirring sounds when it is being used. This is not a
malfunction.
• After use, be sure to disconnect the power supply device from the electrical outlet.
(A very small amount of current is consumed if it is left connected.)
Card and data
Do not leave the card where the temperature is high, where electromagnetic waves
or static electricity are easily generated or exposed to direct sunlight.
Do not bend or drop the card.
• The card may be damaged or the recorded content may be damaged or deleted.
• Put the card in the card case or the storage bag after use and when storing or carrying the
card.
• Do not allow dirt, dust, or water to get into the terminals on the back of the card and do not
touch the terminals with your fingers.
• Recorded data may be damaged or lost if the camera breaks down due to inappropriate
handling. Panasonic will not be liable for any damage caused due to loss of recorded data.
Notice for when transferring to another party, or disposing of the memory card
• Format or delete using the camera or a PC will only modify the file management
information, it will not erase the data in the memory card completely.
• It is recommended to physically destroy the memory card or use the commercially
available computer data deletion software to completely erase the data in the memory
card before transferring to another party or disposing.
• Management of data in the memory card is the responsibility of the user.
About tripods or unipods
• When you use a tripod, make sure the tripod is stable when this unit is attached to it.
• You may not be able to remove the card or the battery when using a tripod or unipod.
• Make sure that the screw on the tripod or unipod is not at an angle when attaching or detaching
the camera. You may damage the screw on the camera if you use excessive force when
turning it. Also, the camera body and the rating label may be damaged or scratched if the
camera is attached too tightly to the tripod or unipod.
• Read the operating instructions for the tripod or unipod.
304

Advertisement

Table of Contents
loading

Table of Contents