Cisco CRS Configuration Manual page 263

Implementing MPLS Layer 3 VPNs
Step 11
show running-config mpls
Example:
RP/0/RP0/CPU0:router# show running-config mpls
Displays the MPLS content of the currently running-configuration.
Step 12
show isis adjacency
Example:
RP/0/RP0/CPU0:router# show isis adjacency
Displays IS-IS adjacency information.
Step 13 show mpls ldp forwarding
Example:
RP/0/RP0/CPU0:router# show mpls ldp forwarding
Displays the Label Distribution Protocol (LDP) forwarding state installed in MPLS forwarding.
Step 14
show bgp vpnv4 unicast or show bgp vrf vrf-name
Example:
RP/0/RP0/CPU0:router# show bgp vpnv4 unicast
Displays entries in the BGP routing table for VPNv4 or VPNv6 unicast addresses.
Step 15 show bgp vrf vrf-name imported-routes
Example:
RP/0/RP0/CPU0:router# show bgp vrf vrf_A imported-routes
Displays BGP information for routes imported into specified VRF instances.
Step 16 show route vrf vrf-name ip-address
Example:
RP/0/RP0/CPU0:router# show route vrf vrf_A 10.0.0.0
Displays the current specified VRF routes in the RIB.
Step 17 show cef vrf vrf-name ip-address
Example:
RP/0/RP0/CPU0:router# show cef vrf vrf_A 10.0.0.1
Displays the IPv4 Cisco Express Forwarding (CEF) table for a specified VRF.
Step 18
show cef vrf vrf-name ip-address location node-id
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Verifying the MPLS Layer 3 VPN Configuration
249