Cisco CRS Configuration Manual page 111

Implementing Multipoint Layer 2 Services
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Step 8 show l2vpn bridge-domain [ detail]
Example:
RP/0/RP0/CPU0:router# show l2vpn bridge-domain detail
Displays detailed sample output to specify that the MAC address withdrawal is enabled. In addition, the sample output
displays the number of MAC withdrawal messages that are sent over or received from the pseudowire.
The following sample output shows the MAC address withdrawal fields:
RP/0/0/CPU0:router# show l2vpn bridge-domain detail
Bridge group: siva_group, bridge-domain: siva_bd, id: 0, state: up, ShgId: 0, MSTi: 0
MAC Learning: enabled
MAC withdraw: enabled
Flooding:
Broadcast & Multicast: enabled
Unknown Unicast: enabled
MAC address aging time: 300 s Type: inactivity
MAC address limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
Security: disabled
DHCPv4 Snooping: disabled
MTU: 1500
MAC Filter:
ACs: 1 (1 up), VFIs: 1, PWs: 2 (1 up)
List of ACs:
AC: GigabitEthernet0/4/0/1, state is up
Type Ethernet
MTU 1500; XC ID 0x5000001; interworking none; MSTi 0 (unprotected)
MAC Learning: enabled
MAC withdraw: disabled
Flooding:
Broadcast & Multicast: enabled
Unknown Unicast: enabled
MAC address aging time: 300 s Type: inactivity
MAC address limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
Security: disabled
DHCPv4 Snooping: disabled
Static MAC addresses:
Statistics:
packet totals: receive 6,send 0
byte totals: receive 360,send 4
List of Access PWs:
List of VFIs:
VFI siva_vfi
Static MAC addresses:
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring the MAC Address-related Parameters
97