Cisco CRS Configuration Manual page 43

Implementing Point to Point Layer 2 services
SUMMARY STEPS
1. configure
2. l2vpn
3. nsr
4. logging nsr
5. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Enters Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RP0/CPU0:router(config)# l2vpn
Enters the Global Configuration mode.
Step 3 nsr
Example:
RP/0/RP0/CPU0:router (config-l2vpn)# nsr
Enables L2VPN nonstop routing.
Step 4
logging nsr
Example:
RP/0/RP0/CPU0:router (config-l2vpn)# logging nsr
Enables logging of NSR events.
Step 5 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring L2VPN Nonstop Routing
29