Cisco CRS Configuration Manual page 36

Configuring Dynamic Point-to-Point Cross-Connects
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. interworking ipv4
6. interface type interface-path-id
7. neighbor ip-address pw-id pseudowire-id
8. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3
xconnect group group-name
Example:
RP/0/RP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Enters the name of the cross-connect group.
Step 4 p2p xconnect-name
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
Enters a name for the point-to-point cross-connect.
Step 5 interworking ipv4
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc)# interworking ipv4
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
22
Implementing Point to Point Layer 2 services