Configuring A Static L2Tpv3 Pseudowire - Cisco CRS Configuration Manual

Implementing Layer 2 Tunnel Protocol Version 3
Example:
RP/0/RP0/CPU0:router(config-l2vpn)# pw-class class100
Enters pseudowire class submode to define a pseudowire class template.
Step 9 encapsulation l2tpv3
Example:
RP/0/RP0/CPU0:router(config-l2vpn-pwc)# encapsulation l2tpv3
Configures L2TPv3 pseudowire encapsulation.
Step 10 protocol l2tpv3 class class - name
Example:
RP/0/RP0/CPU0:router(config-l2vpn-pwc-encap-l2tpv3)# protocol l2tpv3 class wkg
Configures the dynamic pseudowire signaling protocol.
Step 11 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring a Static L2TPv3 Pseudowire

Perform this task to configure a static L2TPv3 pseudowire.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring L2TPv3 Pseudowires
165