Configuration Examples For Multipoint Layer 2 Services - Cisco CRS Configuration Manual

Implementing Multipoint Layer 2 Services
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-grouping
4. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RP0/CPU0:router(config)# l2vpn
RP/0/RP0/CPU0:router(config-l2vpn)#
Enters L2VPN configuration mode.
Step 3
pw-grouping
Example:
RP/0/RP0/CPU0:router(config-l2vpn)# pw-grouping
Enables pseudowire grouping
Step 4
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuration Examples for Multipoint Layer 2 Services

This section includes these configuration examples:
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuration Examples for Multipoint Layer 2 Services
117