Configuring A Backup Pseudowire - Cisco CRS Configuration Manual

Configuring a Bridge Domain
Perform this task to enable pseudowire status TLV.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-status tlv
4. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2
l2vpn
Example:
RP/0/RP00/CPU0:router(config)# l2vpn
RP/0/RP00/CPU0:router(config-l2vpn)#
Enters L2VPN configuration mode.
Step 3 pw-status tlv
Example:
RP/0/RP00/CPU0:router(config-l2vpn)# pw-status tlv
Enables pseudowire status TLV.
Step 4 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring a Backup Pseudowire

Perform this task to configure a backup pseudowire for a point-to-point neighbor.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
74
Implementing Multipoint Layer 2 Services