Cisco CRS Configuration Manual page 91

Implementing Multipoint Layer 2 Services
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RP0/CPU0:router(config)# l2vpn
RP/0/RP0/CPU0:router(config-l2vpn)#
Enters L2VPN configuration mode.
Step 3 pw-class class-name
Example:
RP/0/RP0/CPU0:router(config-l2vpn)# pw-class class_1
RP/0/RP0/CPU0:router(config-l2vpn-pwc)#
Configures the pseudowire class name.
Step 4 backup disable delay seconds
Example:
RP/0/RP0/CPU0:router(config-l2vpn-pwc)# backup disable delay 20
RP/0/RP0/CPU0:router(config-l2vpn-pwc)#
Specifies how long a backup pseudowire virtual circuit (VC) should wait before resuming operation after the primary
pseudowire VC becomes nonfunctional.
Step 5
exit
Example:
RP/0/RP0/CPU0:router(config-l2vpn-pwc)# exit
Exits the pseudowire class submode.
Step 6
xconnect group group name
Example:
RP/0/RP0/CPU0:router(config-l2vpn)# xconnect group A
RP/0/RP0/CPU0:router(config-l2vpn-xc)#
Enters the name of the cross-connect group.
Step 7 p2p xconnect name
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc)# p2p rtrX_to_rtrY
RP/0/RP0/CPU0:router(config-l2vpn-xc-p2p)#
Enters a name for the point-to-point cross-connect.
Step 8 neighbor ip-address pw-id number
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring a Bridge Domain
77