Subwoofer Low Pass Filter - Sony STR-ZA810ES Manual

Mode] and [Dynamic Range Compressor] do not work when the Pure Direct function is selected.
Hint
You can also use PURE DIRECT on the receiver to turn the Pure Direct function on or off.
You can also select [Pure Direct] in [Setup] - [Audio Settings] from the home menu.
[176] Adjusting Settings
Setting the low-pass filter for the subwoofer output

(Subwoofer Low Pass Filter)

You can turn the low-pass filter for the subwoofer output on or off. You can set the function for
each input to which an audio input jack is assigned independently. Turn the function on if you
connect a subwoofer without the crossover frequency function.
Select [Setup] - [Audio Settings] from the home menu.
1
Select [Subwoofer Low Pass Filter].
2
Select the setting you want.
3
On: Always activates the low-pass filter with a cutoff frequency of 120 Hz.
Off: Does not activate the low-pass filter.
Note
This function does not work in the following cases:
[Bluetooth Mode] is set to [Transmitter].
[DSD Native] is set to [On] and DSD signals are being played back.
[177] Adjusting Settings
Synchronizing audio with video output (A/V Sync)
You can delay the output of audio to minimize the time gap between audio output and a visual
display.
This function is useful when using a large LCD or plasma monitor or a projector. You can set
the function for each input independently.
Select [Setup] - [Audio Settings] from the home menu.
1
Select [A/V Sync].
2
Audio Settings
Audio Settings