Performing Auto - Sony STR-ZA810ES Manual

Save the measurement results.
8
Select [Save] in step 7.
Note
If the measurement fails, follow the message, then select [Retry]. For details on the error code and
warning message, see "List of messages after Auto Calibration measurements."
This setting is not available when headphones are connected.
Hint
The Auto Calibration measurement will be canceled if you perform the following during the
measurement process:
Press .
Press the input buttons on the remote control or turn INPUT SELECTOR on the receiver.
Press HOME, AMP MENU, HDMI OUT or
Press SPEAKERS on the receiver.
Change the volume level.
Connect headphones.
Press MUSIC on the remote control or the receiver.
[152] Adjusting Settings
6. Checking Auto Calibration results
To check error codes or warning messages received in [Auto Calibration], proceed with the
following steps:
If an error code appears
Check the error and perform Auto Calibration again.
Select [Retry].
1
Follow the instructions on the TV screen and then press
2
The measurement starts in a few seconds.
The measurement process takes approximately 30 seconds. A test tone is output from
each speaker in sequence.
When the measurement ends, a beep sounds and the screen switches.
Select the item you want.
3
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
Save the measurement results.
4
on the remote control.
Performing Auto Calibration
to select [Start].