Selecting The Front Speakers - Sony STR-ZA810ES Manual

Connect the supplied calibration microphone to the CALIBRATION MIC jack.
1
Set up the calibration microphone.
2
Place the calibration microphone at your listening position and set it at the same height as
your ears.
Note
Insert the plug of the calibration microphone all the way into the CALIBRATION MIC jack. If the
calibration microphone is not connected securely, measurements may not be made properly.
Position the calibration microphone horizontally with the L (left) and R (right) ends at the same
height.
[150] Adjusting Settings

4. Selecting the front speakers

You can select the front speakers you want to operate.
Be sure to use the buttons on the receiver to perform this operation.
Press SPEAKERS on the receiver repeatedly to select the front speaker system you
1
want to operate.
The indicators on the display panel shows which set of terminals are selected.
SPA:
Speakers connected to the SPEAKERS FRONT A terminals.
SPB (*):
Speakers connected to the SPEAKERS SURROUND BACK/HEIGHT terminals.
SPA+B (*):
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND
BACK/HEIGHT terminals (parallel connection).
(None):
[SPK OFF] appears on the display panel. No audio signals are output from any speaker
terminals.
* To select [SPB] or [SPA+B], set the assignment for the SPEAKERS SURROUND BACK/HEIGHT terminals to
[Front B] by using [Surround Back Speaker Assign] in the [Speaker Settings] menu.
Performing Auto Calibration