Power-Saving Setting (Power Save); Transmission Power Setting (Rf Power); Audio Input Level Setting (Input Level); Attenuator Setting (Att) - Sony DWR-R03D Operating Instructions Manual

Power-saving Setting
To conserve power, this setting allows you to change the
transmitter to sleep mode using the wireless remote
control function.
Note
When the setting of the transmitter is changed to sleep
mode, the signal for audio transmission is stopped and the
metadata is also no longer transmitted. For this reason,
"NO DATA" appears for all items in the
TRANSMITTER menu, except for "SLEEP" in the
POWER SAVE indication.
Transmission Power Setting
POWER)
You can change the transmission power of the
transmitter.
Notes
• The transmission power setting depends on the
transmitter function.
• If the maximum transmission power setting of the
transmitter is changed, execute pairing. It may not be
possible to set the transmission power using the
wireless remote control function.
• On 3rd-generation or later digital wireless transmitters
(such as the DWT-B03R), RF POWER cannot be set to
a value higher than 10 mW when BAND is set to TV38
(North American models only).
For details about pairing, see "RF REMOTE Menu"
(page 25).
Audio Input Level Setting
Allows you to change the transmitter's audio input level
setting.
Note
This function may not be supported depending on the
transmitter.
Attenuator Setting
Change the attenuator value when the audio input level
setting of the transmitter is set to MIC.
Note
The attenuator values that can be selected depend on the
transmitter function.
(POWER SAVE)
(RF
(INPUT LEVEL)
(ATT)
Low-cut Filter Setting
The low-cut filter setting of the transmitter can be
changed.
Note
The frequency selection depends on the transmitter
function.
+48 V Power Setting
The +48 V power on the transmitter can be turned on or
off.
Note
This function may not be supported depending on the
transmitter.
Resetting Accumulated Transmitter
Use Time
(TIME)
The accumulated use time of the transmitter can be reset.
Audio codec mode setting
MODE)
Set this setting on the CODEC MODE screen of the
RECEIVER menu.
Set the audio codec mode.
Note
This function may not be supported depending on the
transmitter.
Internal Signal Setting
Specifies whether to generate the transmitter's internal
signal.
Lock Function
Specifies whether to lock the transmitter's POWER button
and lock the settings so that they cannot be changed.
Note
The selection options depend on the transmitter function.
Display Method for Remaining
Battery Capacity
Sets the display method of the remaining battery capacity
of the transmitter.
Notes
• This function may not be supported depending on the
transmitter.
• When set to TIME, the TIME value is displayed at the
display position of the cumulative usage time of the unit
32
(LCF)
(+48V)
(CODEC
(INTERNAL SG)
(LOCK)
(BATTERY REMAIN)