Run/Pause And Stop Of The Master; General Notes On Diagnostics And Error Handling - Festo CPX-FB23 Description

5 Function module F23
5.5.1

RUN/PAUSE and STOP of the master

In the STOP mode of the CC-Link master (e.g. by interruption of communication), the status of the out­
puts in the bit area (RY) and word area (RWw) is dependent on the DIL switch setting HOLD/CLEAR
(è Section 2.4.9).
The following table shows the reaction according to CC-Link specifications:
CC-Link master status
RUN/PAUSE
STOP
Tab. 5.8 RUN/PAUSE and STOP of the master
Note
With STOP, the enable bits of the analogue outputs (control) are set to 0.
The analogue outputs will then also be set.
5.6

General notes on diagnostics and error handling

The instructions and descriptions for diagnostics and error handling in the sections 4.1
and 4.5.2 are also valid for the function module F23.
76
DIL switch setting
CLEAR
Normal operation (Refresh)
The outputs (RY/RWw) are reset.
HOLD
The outputs (RY/RWw) retain their
status.
Festo – P.BE-CPX-FB23-24-EN – 1411b – English