USC LPX Operator's Manual page 38

1. TARGET TREATING RATE:
estimated treating rate in pounds per minute. This number is used by the system to
control the rate of the seed wheel and pumps.
2. PUMP PRE-START TIME:
start time of the pumps based on the proximity sensor in the seed wheel detecting
seed and the timing of the seed wheel turning on. This number will allow the air
actuated 3-way valve to actuate and begin sending liquid to the seed treater a
pre-defined number of seconds before the seed wheel will turn on. This will help
prevent any untreated seed at the beginning of a run.
3. PUMP DELAY SHUT-OFF TIME:
adjust the delay shut-off time of the pumps after the proximity switches located in the
seed wheel do not detect anymore seed.
4. INLET CONVEYOR DELAY RESTART TIME:
operator to adjust the restart time of the inlet conveyor after the proximity switch
located at the top of the inlet hopper above the seed wheel no longer detects seed.
5. TREATER SHUTDOWN TIME:
the delay shutdown time of the seed treater after the SHUTDOWN button has been
pressed after a run. This time will allow the seed treater and any conveyors to
completely clean out.
6. REPORTS:
This button advances the operator to the Reports screen (page 55).
7. PRODUCT SELECTION:
Selection screen (page 49).
8. SECURITY:
This button advances the operator to the Security screen (page 39).
9. ALARMS:
This button advances the operator to the Alarms screen (page 64).
10. CUSTOMER INFO:
Information screen (page 45).
11. INFORMATION:
where the operator can find vital information on storage and troubleshooting.
12. ABOUT USC:
operator what software release is installed.
13. AUTO RATE ADJUST TO BIN SITE:
Tri - Flo™ and USC Bin Site Automation).
Rate will automatically be adjusted to 2% slower than the bin site.
Page 38
LPX AUTOMATED SEED TREATER
Utilities Screen Button Descriptions
Pressing this button allows the operator to adjust the
Pressing this button allows the operator to adjust the
Pressing this button allows the operator to
Pressing this button allows the operator to adjust
This button advances the operator to the Product
This button advances the operator to the Customer
This button advances the operator to the information screen
Pressing this button brings up a popup screen showing the
Pressing this button allows the
(Only present when treater is used with a
When this box is checked, Target Treating