USC LPX Operator's Manual page 14

10. Setup the Automated Main Control panel at a place that is convenient to the
operator. This may include attaching the automated main control panel to the
seed treater, to the wall, or to the control panel stand that will require anchoring.
11. Connect the gray cable with light blue ends to one of PJCAN connections on the
bottoms of both the treater and automated control panels. Connect the two light
blue plugs into each of the remaining open PJCAN connections.
12. Connect the red cable to the PJESTOPA on the treater control panel and then to
the PJESTOPB on the automated control panel. This cable must run from an A
connection to a B connection (never A to A or B to B). Connect the two red plugs
into each of the remaining open PJESTOP connections.
13. Connect the cables from Pump Stand(s) to applicable port on the Main Control
Panel.
Page 14
LPX AUTOMATED SEED TREATER
TREATER SET - UP
LPX AUTOMATED MAIN CONTROL PANEL