USC LPX Operator's Manual page 11

1. Keep safety signs clean and legible at all times.
2. Replace safety signs that are missing or have become illegible.
3. Replaced parts that displayed a safety sign should also display the current sign.
4. Safety signs are available from your Authorized Dealer.
How to Install Safety Signs:

Be sure that the installation area is clean and dry.

Be sure temperature is above 50

Decide on the exact position before you remove the backing paper.

Remove the smallest portion of the split backing paper.

Align the sign over the specified area and carefully press the small portion with
the exposed sticky backing in place.

Slowly peel back the remaining paper and carefully smooth the remaining
portion of the sign in place.

Small air pockets can be pierced with a pin and smoothed out using the piece of
sign backing paper.
LPX AUTOMATED SEED TREATER
SAFETY SIGNS
o
F (10
Located on the USC equipment you will find safety labels.
Always be sure to read and follow all directions on the labels.
Part # 09-02-0001
Guards provided with USC LPX Automated Treater are to
remain in place during operation.
o
C).
Part # 09-02-0002
Page 11