USC LPX Operator's Manual page 34

LPX AUTOMATED SEED TREATER
H-O-A Button Descriptions
1. DRUM CONTROL MODULE:
This module controls the function of the drum. The
HAND button will place the drum in the manual mode of operation. The OFF button
will turn the associated device in the OFF mode of operation. The AUTO button will
place the device in the automatic mode of operation. The motor will not operate in this
function unless all other needed devices are in the AUTO mode and the START button
is pressed on the main screen.
2. DRUM PERCENT SPEED:
When this button is pressed, a numeric touch pad
(bottom) will appear to allow the operator to manually adjust the speed of the drum.
3. ATOMIZER CONTROL MODULE:
This module controls the function of the
atomizer. The HAND button will place the atomizer in the manual mode of operation.
The OFF button will turn the associated device in the OFF mode of operation. The
AUTO button will place the device in the automatic mode of operation. The motor will
not operate in this function unless all other needed devices are in the AUTO mode and
either the PRIME TO ATOMIZER or the START button is pressed on the main screen.
4. ATOMIZER PERCENT SPEED:
When this button is pressed, a numeric touch pad
(bottom) will appear to allow the operator to manually adjust the speed of the atomizer.
5. SEED WHEEL CONTROL MODULE:
This
module controls the function of the seed wheel.
The HAND button will place the seed wheel in
the manual mode of operation. This module
shows the current RPM of the seed wheel
(right). The OFF button will turn the associated
device in the OFF mode of operation. The
AUTO button will place the device in the
automatic mode of operation. The motor will
not operate in this function unless all other
needed devices are in the AUTO mode and the
START button is pressed on the main screen.
6. SEED WHEEL PERCENT SPEED:
When
this button is pressed, a numeric touch pad
(right) will appear to allow the operator to
manually adjust the speed of the seed wheel.
When running in the AUTO mode the program
will override this setting.
Page 34