Preparation For Use - Arjohuntleigh AtmosAir 4000 User Manual

4
Head of Bed Elevation – Keep head of bed as low as possible to help prevent patient migration.
Patient Entrance/Exit – Caregiver should always aid patient in exiting the bed. Make sure a capable patient knows how to get out of bed
safely (and, if necessary, how to release the side rails) in case of fire or other emergency.
Skin Care – Monitor skin conditions regularly and consider adjunct or alternative therapies for high acuity patients. Give extra attention to
skin over any raised side bolster and to any other possible pressure points and locations where moisture or incontinence may occur or collect.
Early intervention may be essential to preventing skin breakdown.
No Smoking in Bed – Smoking in bed can be dangerous. To avoid the risk of fire, smoking in bed should never be allowed.
General Protocols – Follow all applicable safety rules and institution protocols concerning patient and caregiver safety.
Disposal – At the end of useful life, dispose of waste according to local requirements or contact the manufacturer for advice.

Preparation for use

1. Open shipping container(s).
Do not use sharp instruments to open boxes. Damage to mattress could result.
2. Remove AtmosAir™ MRS from plastic protective cover.
i The mattress cover may appear wrinkled when unpacked. To remove wrinkles, allow
mattress up to 24 hours to accommodate; see Troubleshooting table on page 7 for more
information. Wrinkles will not affect inflation or function, so MRS may be used immediately
if needed.
3. Check mattress surface for tears or cracking; do not use if tears or cracks are present.
4. If re-installing MRS onto a new frame or for a new patient, check mattress surface for staining and soiling; clean and/or disinfect
as required (see Care and Cleaning section on page 6).
5. Level bed and lock brakes.
6. Remove existing mattress from bed frame.