Mattress Installation; Patient Placement And Nursing Care; Cpr; Skin Care - Arjohuntleigh AtmosAir 4000 User Manual

Mattress installation

1. Position mattress on bed frame with logo facing up and product information tags at foot end of bed.
i
Magnets are integrated on the AtmosAir™ T-Series* bottom cover to help keep the mattress
in place during foot section extension/retraction.
2. Ensure mattress is properly positioned with no gaps between mattress and bed frame or side rails.
Always use a standard healthcare bed frame with safeguards or protocols that may beappropriate. Frame and
side rails must be properly sized relative to the mattress
to helpminimize any gaps that might entrap a patient's head or body.
*T-Series is compatible for use with the Hill-Rom Total Care bed frame. Total Care is a trademark of Hill-Rom and/or its affiliates.

Patient placement and nursing care

It is recommended that all sections of this manual be read prior to patient placement and nursing care. Carefully review the Contraindications,
Safety Information, and Risks and Precautions sections prior to placing a patient on any AtmosAir™ MRS.
1. Transfer patient following all applicable safety rules and institution protocols.
2. Center patient side-to-side and head-to-foot on AtmosAir™ surface.

CPR

1. Level bed.
2. Lower or remove side rail on caregiver's side if necessary.
3. Begin CPR.
4. After CPR is performed:
• Raise or install side rail as necessary.
• Reconfigure bed and accessories as in initial placement.

Skin Care

• Remove excess moisture and keep skin dry and clean.
• Check patient's skin regularly, particularly in area where incontinence and drainage occur.
• Ensure linens under patient are not wrinkled.

Incontinence/Drainage

• Use moisture-impermeable underpads for incontinent patients.
• Wipe surface clean and replace bed linens as required (see Care and Cleaning section on page 6 for
cleaning instructions, if needed).

General Operation

Avoid contact of sharp instruments with the AtmosAir™ MRS. Punctures, cuts and tears
may prevent proper inflation and air pressure maintenance.
5