Uefi Device Manager - DFI WM343-KD330 User Manual

UEFI Device Manager

This Device Manager menu is used to configure UEFI network settings when the "Network
Stack" is enabled in the "Dual" or "UEFI" boot mode or when the PXE Boot to LAN is enabled
in the "Legacy" boot mode. Refer to the "Boot" section in this chapter. After this function is
selected, the screen will warn you that you are going to exit the BIOS setup utility.
Chapter 7 BIOS Setup
Chapter 7
Network Device List
The "Device Manager" screen is displayed. And if the "Network Stack" or the "PXE Boot to
LAN" option is enabled from the "Boot" menu, the "Network Device List" should be shown
in the "Device list". Select "Network Device List" to view all of the detected network devic-
es. For each network device, you can select to view and configure its settings. In addition,
you can select either the IPv4 or IPv6 network settings for UEFI network configuration.
NIC Configuration Menu
This screen shows hardware information for the Ethernet controllers and configures
their operation.
55
www.dfi.com