Advertisement
Quick Links
Quick Installation Guide
WM343-KD
Package Contents
Panel
Rear View
(WM343-KD330/WM343-KD331)
drive bay
Opening the Chassis
Please observe the following guidelines and follow the procedure to open the system.
1.
Make sure the system and all other peripheral devices connected to it have been powered off.
2.
Disconnect all power cords and cables.
3.
Remove the top cover by uninstalling the thumb screws.
DFI reserves the right to change the specifications at any time prior to the product's release.
This QIG may be based on editions that do not resemble your actual products. For the latest
revision and more details of the installation procedure, please refer to
go.dfi.com/WM343-KD330 and go.dfi.com/WM343-KD331or scan the QR codes on the right.
• One WM343-KD330/WM343-KD331 system unit
• Screw pack and SATA cable for SATA drive installation
• 1 CPU cooler and 1 system fan
• HDD mounting screws
Power LED (green)
Power button
SATA
Optical drive bay
(optional)
HDD LED (red)
RESET
LAN 1 LAN 2
PS/2 KB/MS
USB 3.0 1-4
USB 2.0 1-2
COM1
VGA
DVI-I
(DVI-D signal)
DP++
Thumb screw
www.dfi.com
Expansion card slot
for KD331:
LAN 3
LAN 4
or
for KD330:
Line-out
Mic-in
WM343-KD330 WM343-KD331
1
Advertisement
Related Manuals for DFI WM343-KD
Summary of Contents for DFI WM343-KD
- Page 1 Remove the top cover by uninstalling the thumb screws. Thumb screw DFI reserves the right to change the specifications at any time prior to the product's release. This QIG may be based on editions that do not resemble your actual products. For the latest revision and more details of the installation procedure, please refer to go.dfi.com/WM343-KD330 and go.dfi.com/WM343-KD331or scan the QR codes on the right.
- Page 2 Installing a DIMM To access the DIMM sockets, first remove the CD tray by uninstalling the screws from the rear panel and inside the chassis. CD tray screw CD tray screw To install a DIMM, align the notch on the DIMM with the tab in the DIMM connector. Then press down on the DIMM until the release tabs spring back to secure the DIMM in place.
- Page 3 Installing a 3.5" or 2.5" SATA Drive Remove the thumb screws that secure the HDD drive bay to the chassis and remove the drive bay. Thumb screw Secure the hard drive to the drive bay. Align the mounting holes on the SATA drive with the mounting holes on the HDD drive bay.
- Page 4 Board Layout and Jumper Settings RS232/422/485 JP7 (COM 1) JP11 (COM 2) (WM343-KD330) RS232 (default) 1-2 On COM 1 (DDR4_2, DDR4_4 for KD330-Q170 only) RS232/422/485 DDR4_2 DDR4_4 Select (JP7) DDR4_1 DDR4_3 RS422 Full Duplex 3-4 On PS/2 KB/MS COM 1 RS232/Power Select (JP9) USB 5-6 System Fan 1 CPU Fan...