DFI WM343-KD330 User Manual page 17

Installing a 3�5" or 2�5" SATA Drive
1. Remove the thumb screws that secure the HDD drive tray to the chassis and remove the
drive tray.
Thumb screw
2. Secure the hard drive to the drive tray. Align the mounting holes on the SATA drive with the
mounting holes on the HDD drive tray. Use 4 mounting screws to install the hard drive onto
the HDD drive tray.
Drive bay
Mounting screw
Chapter 3 Installing Devices
Mounting screw
3�5" SATA Drive
Chapter 3
Use the same HDD drive tray to secure a 2.5" hard disk to the system. Refer to the pictures below
for the location of the mounting holes.
17
Mounting screw
Mounting screw
2�5" SATA Drive
www.dfi.com