Table of Contents
Advertisement
ACPI Settings
This section configures system's ACPI parameters.
Wake on LAN
Enable or disable WOL (wake-on-LAN) to wake the system through an Ethernet adapter.
Wake on PS/2
Enable or disable the use of PS/2 devices to wake the system.
After G3
Specify which state the system should be in when power is re-applied after a power
failure (G3, the mechanical-off, state).
Always On The system is powered on.
Always Off The system is powered off.
Wake on RTC/Wake up Time
Enable this function to automatically power the system up at a particular time every day
from the real-time clock battery. Specify the wake up time of the day below: <hour>,
<minute>, <second>. The default is disabled.
Chapter 7 BIOS Setup
Chapter 7
CPU Configuration
This section configures the CPU.
Intel
SpeedStep™
®
Enable or disable the Enhanced Intel SpeedStep
balance between system's power consumption and performance. After it is enabled in the
BIOS, you can take advantage of its offering by setting power schemes from the operating
system's power options.
Turbo Mode
Enable or disable processor turbo mode, which allows the processor core to automatically
run faster than the base frequency by taking advantage of thermal and power headroom.
CPU C States
Enable or disable CPU Power Management. It allows the CPU to go to C states when it's
not 100% utilized.
Hyper-Threading
Enable Intel
Hyper-Threading Technology (HT) on the processor to improve performance
®
of operating systems and software that are optimized for hyper-threading technology.
Please check the software specifications to determine if enabling HT can be advantageous
to the overall system performance.
49
Technology, which helps optimize the
®
www.dfi.com
Advertisement
Table of Contents
