Forward, Reverse, And Acceleration - TOHATSU MFS 40A Owner's Manual

46
ENGINE OPERATION
2
1
1. Neutral throttle button
2. Forward
ENOM00880-A
Trolling speed control
If the main switch key is pressed for 1
(one) second during idling or trolling
operation, engine speed changes each
time the main switch key is pressed.
7
Engine speed changes as follows.
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
Starting
-1
850 min (rpm)
-1
950 min (rpm)
Buzzer makes one short sound when the
engine speed is set to 650 min
indicating the minimum trolling speed is
set.
Buzzer makes two short sound when the
engine speed is set to 950 min
ENOF00935-0
ON
1
second
ENOF00876-0
-1
750 min (rpm) 650 min
-1
850 min (rpm) 750 min
-1
-1
indicating the maximum trolling speed is
set.
Trolling speed control function will reset
and trolling speed is set to 850 min
( r p m ) w h e n t h e e n g in e s p e e d is
increased above 3,000 min
after the engine restarted.
If battery voltage is lower than specified
value, this function does not operate, and
trolling speed is controlled to 850 min
(rpm) automatically.
ENOM00046-A
4. Forward, reverse, and
acceleration
ENOW00037-1
Before shifting into forward or reverse, make
sure that boat is properly moored and out-
board motor can be steered fully to the right
and left. Make sure that no swimmer(s) is
around of the boat.
ENOW00967-0
Attach the other end of emergency stop
switch lanyard to the operator's PFD (Per-
sonal Flotation device) or arm and keep it
attached during cruising.
Do not attach the lanyard to a part of
-1
(rpm)
clothing that can be torn easily when
pulled.
-1
Arrange the lanyard so that will not be
(rpm)
caught by any object when pulled.
Be careful not to pull the lanyard acciden-
tally during cruising. Unintentional stop of
(rpm),
engine can cause loss of control of out-
board motor. Rapid loss of engine power
can lead to fall down or causing passen-
ger(s) to be thrown overboard.
(rpm),
-1
(rpm) or
WARNING
WARNING
-1
-1