Functions Of Printer Programs - Nortec UL60 Operation Manual

6 Handling

6.7 Functions of printer programs

The device is equipped with an inbuilt printer. Thus, it is possible to record the results of the
treatments and to get a print for each battery. Independant from the charging routine the print
menu can be changed at each time.
Printer programs
General information
Press the key
Program P: Printer and cell voltage measurement
With the P program at any time a printout can be generated - without or within a program run, esp.
in connection with the measurement and recording of the single cells voltages.
Distinguish between the following possibilities:
Automatic printed record within a program

 Manual printed record within a program
NOTE: Automatic printed record is only possible in connection with an automatic cell tester
(optional)
Manual cell tester
NOTE FOR ALL PRINTER APPLICATIONS
The capacity indication in % is related to the rated capacity of the battery.
The printed line TEMPERATURE is just shown if the plus- and minus cable have a thermistor. For
lead-acid batteries, both poles are measured and shown the value with the respectively higher
temperature.
The single cells measurement is just possible using manual printed record and is announced by
three short beeps. At this moment, it is possible to messure and to print the single cell voltages
using a single cell tester. At maximum 99 cell measurements are possible.
30
in main menu or sub menu and you will get the last print again.
Automatic cell tester
© Nortec Electronics 2018