Modbus (Slave) - Beko METPOINT BDL compact Instructions For Installation And Operation Manual

Operation METPOINT® BDL compact

14.3.3.4 ModBus (slave)

With the RS485 ModBus
®
with the METPOINT BDL compact.
Main menu  Settings  Device settings ModBus settings
METPOINT® BDL compact
interface, customer-specific systems (GLT, SPS, Scada) can be connected
Here the transmission parameters
rate, stop bit and parity
tick for enable Modbus
be activated.
By pressing the Set to default
justed default values are set.
Default values: Baud rate:
Stop bit:
Parity:
When the BDL compact is connected to the end of
the bus, the termination can be activated via the
Term button, or a BIAS energised via the
ton.
With the TCP and RTU
change the data format (word order).
The default value for both modes is: C-D-A-B
Changes need to be confirmed by pressing the
pres... button.
Modbus ID, baud
must be set. By setting the
RTU(RS485), Modbus will
button, the pre-ad-
19200
1
even
Bias
buttons, it is possible to
63
but-