Wing Installation - Seagull Models Magic Star 3D EP Assembly Manual

2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.

WING INSTALLATION.

1) Remove covering from the fuselage by
using knife.
2) Slide the aluminum tube into the sock-
et in the fuselage.
3) Insert two wing panels as shown.
WWW.SEAGULLMODELS.COM
Wing tube.
BALANCING.
1) It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED 89MM BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
2) Mount the wing to the fuselage. Using
a couple of pieces of masking tape, place
them on the bottom side of the wing
89mm back from the leading edge of the
wing at the wing root.
3) With the model upright, place your
fingers on the masking tape and carefully
lift the plane.
Wing bolt.
19