Viewing And Changing Link Settings For Ethernet Interfaces - ShoreTel 4500 Installation Manual

Chapter 4
4.1.3.1 Adding a Static Route
To add a static route, enter the following information:
Parameter
IP Network
Network mask
Gateway
4.1.3.2 Deleting a Static Route
To delete one or more routes:
1. Enable the checkbox(es) next to the route(s) to delete. To delete all entries, click on the
All link.
2. Click Delete.
4.1.4

Viewing and Changing Link Settings for Ethernet Interfaces

The Set Link page displays the current Ethernet interface link settings for the system. If
needed, you can manually set the rate for each interface to establish a reliable connection.
You can also adjust the MTU size of the WAN interface to reduce the effects of large data
packet on media data.
To access the Set Link page, select System  Set Link from the Configuration Menu.
VPN Concentrator Installation and Configuration Guide
Enter the remote network address or host.
Enter the subnet mask for the subnet. When defining a
host route, the netmask should be 255.255.255.255.
Enter the address of the router on this device's LAN
network, that is routing for the remote network or host.
Caution:
Use care when configuring static routes. They may prevent network
features of the system from functioning properly.
Configuring the VPN Concentrator
Description
33