Table of Contents
Advertisement
Chapter 1
1.4.2.2
VPN Concentrator 5300LF2
Component
A
B
C
D
E
F
G
H
I
VPN Concentrator Installation and Configuration Guide
Figure 1-5 Front Panel (5300LF2)
Description
Erase
• If pressed twice in quick succession, the CLI password will be changed
to its default password.
• If pressed three times in quick succession, the 5300 will revert to factory
default settings. All passwords will be reset and all prior configurations
will be erased.
Note: The default LAN address is set to 192.168.1.1
Caution: Setting the system configuration to factory default will erase all
configuration changes.
Console Port – This port is used to establish a console session with the 5300.
Power LED
Off – Power switch is off (or no power from the AC outlet).
Solid Green – Power is supplied to the unit.
Port 3 (Management Port) – Can be used as an out-of-band management
port.
Caution: Once enabled, HTTP , SSH, SNMP , and TELNET sessions will only
be allowed through this port, and will no longer be available on Port 1 or
Port 2.
Port 2 (WAN Port) – Connects to the upstream router.
Note: This port requires an IP Address. If you do not know the IP Address
assigned to the WAN Interface, contact your system administrator.
Port 1 (LAN Port) – Connects to the local network or LAN.
Caution: The device is pre-configured with an assigned LAN IP Address of
http://192.168.1.1. Changing the LAN IP Address may result in loss of your
VPN connection.
2 x USB ports – Not used.
Disk Activity LED
• Off – No disk activity
• Flashing Red – Data is being read or written to the disk.
Reset– Press the Reset button once to soft reboot the 5300. The 5300 will
reboot using the last saved configuration.
Hardware Features
7
Hide quick links:
Advertisement
Table of Contents
