ShoreTel 4500 Installation Manual page 10

Hardware Features
Component Description
A
B
C
D
E
F
G
H
4
Power Connector – Accepts the plug from the supplied power adapter
which can be connected to an AC outlet on the wall using the supplied
power adapter.
4 Ports 10/100 Mbps LAN Switch – Four ports that can be used to connect
to the Local Area Network (LAN) network.
Note: Port 1 is assigned a pre-configured IP address of http://192.168.1.1.
Additional Note: LAN port 4 can be used as a port-based VLAN. LAN ports
1 through 3 can be used as a tag-based or port-based VLAN.
USB Ports – Not used.
Ethernet WAN Port – This port is used to connect the 4500/4550 to an
upstream router.
Note: This port requires an IP Address. If you do not know the IP Address
assigned to the WAN Interface, contact your system administrator.
Management Console Port – This port is used to establish a local console
session with the 4500/4550 using a VT100 terminal or emulation program.
The cable required is a straight-through 8-wire cable with female connector.
The serial port uses a baud rate of 9600, 8 data bits, 1 stop bit and no parity.
This port is used for debug or local diagnostic purposes only. Primary con-
figuration of the 4500/4550 is performed from a web browser as covered in
Chapter 3.
Erase
• If pressed twice in quick succession, the CLI password will be changed
to its original password.
• If pressed three times in quick succession, the4500/ 4550 will revert to
factory default settings. All passwords will be reset and all prior
configurations will be erased.
Note: The default LAN address is set to 192.168.1.1
Caution: Setting the system configuration to factory default will erase all
configuration changes.
Link Status LED
• Solid Green – Ethernet link is up.
• Blinking Green – Indicates activity on the link.
Link Speed LED
• Off – If the link is up, indicates that the port is connected to a 10BaseT
Ethernet switch or hub.
• Solid Amber – Indicates that the port is connected to a 100BaseT
Ethernet switch or hub.
Chapter 1