Allen-Bradley 1734-IM4 User Manual page 187

a. Click a channel push button, such as 0 or 1, which is highlighted to
show it was pressed, selecting the corresponding channel for the values you
enter.
b. Enter values for low and high alarms in one of these ways:
• Type the numeric value.
• Drag the pointer on the corresponding slider control.
c. Choose unlatch options one of the following ways:
• Click Unlatch next to an individual alarm.
• Click Unlatch All to unlatch all the alarms at once.
d. Check the checkbox for the following, if desired:
• Disable All Alarms - A check in the checkbox tells the module to not
report alarms. This is disabled in Hard Run mode only.
• Latch Process Alarms - A check in the checkbox lets you latch transient
alarm conditions. This is disabled in Hard Run mode.
e. Click OK
Work with the Calibration Dialog
To complete entries on this dialog proceed as follows. Perform calibration in
Hard Run or Remote mode. For information about the tools and steps for
calibration, refer to the Calibrating Your Analog Module section of this manual.
1. From the General dialog, click Calibration.
You see the Calibration dialog for a current or voltage input module,
depending on the module type.
See the figure for a Calibration dialog for a current input module.
Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
Configure POINT I/O Modules in RSLogix 5000 Software 195